This article is from the source 'guardian' and was first published or seen on . It last changed over 40 days ago and won't be checked again for changes.

You can find the current article at its original source at https://www.theguardian.com/australia-news/2017/jul/13/melbournes-peak-hour-trains-at-a-standstill-after-computer-glitch

The article has changed 5 times. There is an RSS feed of changes available.

Version 1 Version 2
Melbourne train services resume after IT glitch brings network to a standstill Melbourne train services resume after IT glitch brings network to a standstill
(35 minutes later)
Melbourne’s train services have resumed after a network wide technical glitch, but long delays are expected as thousands of commuters try to squeeze aboard. Melbourne has suffered through peak hour commuter chaos after a computer glitch shut down the entire train network, leaving thousands of passengers stranded.
A computer fault shut down every rail line at the start of peak hour, leaving passengers stranded between stations and on platforms. The fault brought every line to a grinding halt at about 4pm on Thursday, leaving people stuck on trains between stations - some even trapped underground in the City Loop for two hours.
Services resumed shortly after 5.30pm, but Metro Trains was still warning commuters to allow for extra time and to defer travel where possible. Metro tweeted a warning for people not to force the doors and make a getaway from the stranded trains, and were advising people at stations to “seek alternative transport where possible”.
The peak hour debacle also affected Melbourne’s tram networks, with Yarra Trams also saying “high demand” was contributing to major delays.Uber prices skyrocketed, with a five-minute trip – which would usually cost about $8 to $10 – shooting up to about $43. Services resumed shortly after 5.30pm, but by that time, platforms were clogged with angry commuters – some demanding compensation for the delay.
Commuters were not impressed with the delays and many took the opportunity to vent on social media or poke fun. Pictures on social media showed people crammed into train carriages in the desperate push to get home once services resumed.
Metro Trains tweeted: “crowd control measures are in place at Sthn Cross and City Loop stations. Pls allow extra time to enter & follow directions from staff.”
There are still delays across the network, which are likely to persist for most of the night.
VicRoads also issued a warning that boom gates may be down for long periods due to the sudden influx in trains.
The peak hour debacle also affected Melbourne’s tram networks, with Yarra Trams saying “high demand” was contributing to major delays.
Commuters took the opportunity to vent on social media or poke fun at Metro, the train network operator, over the situation.
Update: Services are now running. In other capital cities, that is. Not Melbourne. #MetroTrainsUpdate: Services are now running. In other capital cities, that is. Not Melbourne. #MetroTrains
Leaked footage of #MetroTrains attempting to get their system back online. pic.twitter.com/kWspagMrLzLeaked footage of #MetroTrains attempting to get their system back online. pic.twitter.com/kWspagMrLz
You had one job @metrotrains #MetroTrains pic.twitter.com/vR67V2gmQzYou had one job @metrotrains #MetroTrains pic.twitter.com/vR67V2gmQz
Metro said the computer glitch had been fixed, apologised and promised a full investigation into what caused it.
It is believed the TCMS, the network’s automated control centre, was behind the failure with controllers left staring at blank screens when it went offline. The trains were required to halt for safety reasons as controllers had no way of knowing where they were.It is believed the TCMS, the network’s automated control centre, was behind the failure with controllers left staring at blank screens when it went offline. The trains were required to halt for safety reasons as controllers had no way of knowing where they were.